330703-000-040-10-12-00 BENTLY NEVADA Probes and Extension Cables

330703-000-040-10-12-00 is an Extension Cable developed by Bently Nevada.  This extension cable is designed to connect proximity probes to Proximitor Sensors, forming a complete and reliable system for machinery vibration and position monitoring.

Features:

• System Compatibility

Specifically designed for use with Bently Nevada’s 3300 XL series proximity probes and Proximitor Sensors. The cable ensures accurate signal transmission for critical machine monitoring.

• Cable Length

8.0 meters (26.2 feet) total length, suitable for medium-range installations where sensors are located at a moderate distance from monitoring equipment.

• Connector Type

Features standard coaxial connectors, providing a secure, reliable electrical interface with probe and sensor components.

• Cable Type

Constructed with standard cable insulation and shielding, offering protection against electrical noise and signal degradation in industrial environments.

Frequently asked questions about 330703-000-040-10-12-00:
1.How can I tell if the probe is damaged?
-Inspect the appearance: Cable damage, oxidized connectors.
-Measure resistance: The probe coil resistance is typically 5-50Ω. An open or short circuit indicates a failure.
-Signal test: Connect the probe to the target and observe whether the output is zero when there is no contact.
2.What precautions should be taken during installation?
-Distance between probe and target: Initial gap voltage calibration is required.
-Avoid cable bends with a small radius to prevent shield damage.
-Keep away from sources of strong electromagnetic interference.
3.Possible causes of abnormal probe output signals?
-Changes in target surface material.
-Poor contact in the cable connector.
-Proximitor power supply failure.

Datasheet Link:

330703-000-040-10-12-00 BENTLY NEVADA Probes and Extension Cables  PDF Datasheet